Regular Cab With Bucket Seat

1. Install the buckle assembly to the floor panel.
2. Install the seat belt warning wire to the buckle assembly on the driver's side only.

Notice: Refer to Fastener Notice in Cautions and Notices.





3. Install the nut to the buckle assembly and onto the floor panel weld stud.

Tighten
Tighten the nut to 42 N.m (31 lb ft).





4. Install the cover assembly over the nut.
5. Install the retractor and belt to the floor.
6. Install the bolt through the retractor into the floor panel weld nut.

Tighten
Tighten the bolt to 55 N.m (41 lb ft).

7. Install the bolt through the anchor plate and washer into the door pillar weld nut.

Tighten
Tighten the bolt to 55 N.m (41 lb ft).

8. Install the cover over the door pillar anchor plate.