Front Wheel Toe Adjustment

Measure toe-in at the following locations:
- From the center of the tire treads or from the inboard side of the tires
- At the front and the rear of the axle
- At the horizontal axis of the wheel
When setting the toe-in adjustment, neutralize the front suspension. Ensure that all component parts are in the same relative position when making the adjustment as they will be when in operation. In order to neutralize the suspension, roll the vehicle 3.5-4.5 meters (12-15 ft.). When the vehicle is rolled forward, all normal tolerances in the suspension and the steering linkage are in the correct operating position. Neutralize the front suspension if the vehicle has been raised.
1. Loosen the tie rod adjuster sleeve nuts.
2. Turn the tie rod using a pipe wrench until the wheels have the proper toe-in.
Set
Toe total degrees should be within 0.0° to 0.24° preferred is 0.12° or Total toe in mm, in should be within 0.0 to 0.12 in preferred is 0.06 in.

Notice: Refer to Fastener Notice in Service Precautions.

3. Tighten the tie rod adjuster sleeve nuts.
- Tighten the tie rod adjuster sleeve nuts to 45 Nm (33 ft. lbs.).