Horn: Service and Repair

REMOVAL PROCEDURE
1. Raise the hood.
2. Remove the headlamp assembly.
3. Remove the park/[1][2]turn signal lamp assembly.
4. Disconnect the horn electrical connector.
5. Remove the horn attaching bolt. Reposition the park/[1][2]turn signal lamp wiring harness for additional clearance.
6. Remove the horn (2) from the radiator support (1). Left side and right side horn assemblies are shown.

INSTALLATION PROCEDURE
1. Install the horn (2) to the radiator support (1). Left side and right side horn assemblies are shown.

Notice: Refer to Fastener Notice in Cautions and Notices.

2. Install the horn attaching bolt.

The horn should have the black side facing forward on the vehicle.

Tighten
Tighten the bolts to 9 N.m (80 lb in).

3. Connect the horn electrical connector.
4. Install the park/[1][2]turn signal lamp assembly.
5. Install the headlamp.
6. Lower the hood.