75. Oil Pump, Pump Screen and Deflector Installation

1. Inspect for properly installed oil pump locating pins.





IMPORTANT: During assembly, install a NEW oil pump driveshaft retainer. Slightly heat retainer above room temperature for ease of installation onto the oil pump driveshaft.

2. Assemble the oil pump, driveshaft, and a NEW retainer.
3. Install the oil pump assembly. Position the oil pump onto the locating pins.

NOTICE: Refer to Fastener Notice in Service Precautions.

4. Install the bolt attaching the oil pump to the rear crankshaft bearing cap.
^ Tighten the oil pump bolt to 88 Nm (65 lb ft).