Air Temperature Sensor ( Ambient / Intake ): Service and Repair

REMOVAL PROCEDURE

CAUTION: Before servicing any electrical component, the ignition key must be in the OFF or LOCK position and all electrical loads must be OFF unless instructed otherwise in these procedures If a tool or equipment could easily come in contact with a live exposed electrical terminal, also disconnect the negative battery cable Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its components.




1. Remove the negative battery cables.
2. Remove the electrical connector.




3. Remove the IAT sensor.

INSTALLATION PROCEDURE

NOTE: Refer to Fastener Notice in Cautions and Notices.




1. Install the IAT sensor.

Tighten
Tighten the IAT sensor to 25 N.m (18 lb ft).




2. Install the electrical connector.
3. Install the negative battery cables.