Fasten Seat Belts

Outputs:

IMPORTANT: The output table does not list all of the IPC LEDs. The PC LEDs not listed are controlled by a different device. Refer to the applicable device when diagnosing IPC LEDs not shown in the table above.

Range: ON/OFF

This output refers to the commanded state of the FASTEN SEAT BELTS lamp illumination by the IPC module.

ON is displayed under the following conditions:
^ When the IPC module commands the FASTEN SEAT BELTS lamp to be illuminated for 20 seconds. The illumination is followed by 55 seconds of flashing, a Class 2 message received from the Body Control Module (BCM) indicating the driver seat belt is not fastened.
^ During the bulb check period for 3 seconds after the ignition switch is first turned to the RUN position, providing the driver' buckle is fastened.

OFF is displayed when the IPC module is not commanding the FASTEN SEAT BELTS lamp to be illuminated.