Assist Step Replacement (Diamond Edition)

Assist Step Replacement (Diamond Edition)

Removal Procedure




1. Remove 6 nuts and 3 U-bolts securing the assist step assembly to the mounting brackets.
2. Remove the plastic end caps from the assist step assembly if required.

1. Remove the 3 screws from the assist step assembly.
2. Remove the plastic end cap by pulling the cap straight out of the step assembly.

3. Remove the plastic step pads if required by breaking the plastic pad from the assist step assembly.

Installation Procedure




1. Install new plastic step pads to the assist step assembly by pressing the new pad into place.
2. Install the plastic end cap to the assist step assembly.

1. Install the plastic end cap by pressing the cap straight into the assist step assembly.
2. Install 3 screws into the step assembly.

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the assist step assembly to the mounting brackets with 3 U-bolts and 6 nuts.

Tighten the step assembly nuts to 20 N.m (15 lb ft).