Closeout/Insulator Panel Replacement - Center

Closeout/Insulator Panel Replacement - Center

Removal Procedure




1. Remove the center console from the vehicle if equipped with RPO code YC7 (GMC Envoy).
2. Remove the screws that retain the instrument panel sound insulator to the following components:
* The knee bolster
* The instrument panel
* The heater assembly
* The floor duct

3. Remove the instrument panel sound insulator from the vehicle.
4. Disconnect the electrical connector from the accessory power outlet (if equipped).

Installation Procedure

1. Connect the electrical connector to the accessory power outlet (if equipped).




2. Install the instrument panel sound insulator to the vehicle.

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the screws that retain the instrument panel sound insulator to the following components:
* The knee bolster
* The instrument panel
* The floor duct

Tighten the screws to 1.5 N.m (13 lb in).

4. Install the screw that retains the instrument panel sound insulator to the heater assembly.

Tighten the screw to 1.5 N.m (13 lb in).

5. Install the center console to the vehicle if equipped with RPO code YC7 (GMC Envoy).