Horn Switch

REMOVAL PROCEDURE





1. Remove the inflator module. Refer to Infl Rst Steering Wheel Module Replacement in Air Bags and Seat Belts.
2. Remove the horn plunger from the steering column by pressing inward to the stop and rotating horn plunger 90 degrees.





3. Remove the horn contact plate retaining screws from the steering wheel.
4. Remove the horn plunger from the steering wheel.

INSTALLATION PROCEDURE





1. Install the horn plunger to the steering wheel.

NOTICE: Refer to Fastener Notice in Service Precautions.

2. Install the horn contact plate retaining screws to the steering wheel.
- Tighten the horn contact plate retaining screws to 5.5 Nm (50 inch lbs.).





3. Install the horn plunger to the steering column.
4. Install the inflator module. Refer to Infl Rst Steering Wheel Module Replacement in Air Bags and Seat Belts.