2-Door Utility

REMOVAL PROCEDURE





1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the following parts from the stabilizer links:
- The lower nuts
- The washers
- The bolts





3. Remove the nuts from the U-bolts.
4. Remove the following parts:
- The U-bolts
- The clamps
- The insulators
5. Remove the stabilizer shaft.

INSTALLATION PROCEDURE





1. Install the stabilizer shaft to the rear axle.
2. Install the following parts:
- The insulators
- The clamps
- The U-bolts

NOTICE: Refer to Fastener Notice in Service Precautions.

3. Install the nuts to the U-bolts.
- Tighten the nuts to 60 Nm (44 ft. lbs.).





4. Install the stabilizer shaft to the link mountings bolt.
5. Install the stabilizer shaft to the link nut.
- Tighten the upper link nut to 35 Nm (25 ft. lbs.).
6. Lower the vehicle.