Instruments - Inaccurate/Erratic Compass Operation
Bulletin No.: 03-08-49-008ADate: February 26, 2004
TECHNICAL
Subject:
Erratic or Inaccurate Compass Operation with Use of Power Sunroof (Replace Compass Sensor Mounting Bracket and Calibrate Compass)
Models:
1999-2004 Chevrolet Blazer
1999-2004 GMC Jimmy
1999-2001 Oldsmobile Bravada
with Roof, Sun, Glass Sliding, Electric (RPO CF5) and Console Roof Interior, Custom, Compass and Outside Temperature (RPO DK7) or Console Roof Interior, Deluxe (RPO DK8)
Supercede:
This bulletin is being revised to include additional model years. Please discard Corporate Bulletin Number 03-08-49-008 (Section 08 - Body and Accessories).
Condition
Some customers may comment that the compass is intermittently erratic or inaccurate while operating the power sunroof. The compass may stay erratic or inaccurate while the power sunroof is open.
Cause
The sunroof module cable may become magnetized with the operation of the sunroof, producing a false signal to the compass sensor.
Correction
Follow the service procedure below to relocate the compass sensor by replacing the compass sensor bracket.
Compass Sensor Mounting Bracket Replacement Procedure
1. Remove the rearview mirror.
2. Remove the sunshades and the retainers.
3. Remove the right front assist handle.
4. Remove the windshield garnish moldings.
5. Remove the body lock pillar trim panels.
6. Remove the screw at the front of the console.
7. Pull downward on the rear of the console in order to remove the sunroof console from the roof.
8. Disconnect the electrical connectors (1, 5, 6) as needed.
9. Remove the sunroof console.
Note:
Use caution not to damage or crease the headliner while repositioning.
10. Reposition the front of the headliner down and out of the way of the compass mounting bracket.
11. Remove the screw that retains the sunroof console mounting bracket to the roof.
12. Remove the compass sensor mounting bracket from the vehicle.
13. Remove the front center clip-in retainer from the compass sensor mounting bracket.
14. Install the clip-in retainer on the new compass sensor mounting bracket, P/N 15106819.
15. Trim the headliner as shown above in order to allow clearance for the new compass mounting sensor bracket. Follow the dimensions below for the trimming of the sensor bracket.
^ A = 71 mm (2.8 in)
^ B = 19 mm (0.75 in)
^ C = Center line of headliner
^ D = 9.5 mm (0.375 in)
16. Install the new compass mounting bracket.
17. Install the compass mounting bracket screw.
Tighten
Tighten the screw to 1.9 N.m (17 lb in).
18. Connect the console electrical connectors.
19. Insert the console mounting tabs into the mounting bracket and push upward on the rear of the console in order to install the console.
20. Install the screw at the front of the console.
Tighten
Tighten the screw to 1.9 N.m (17 lb in).
21. Calibrate the compass.
Parts Information
Parts are currently available from GMSPO.
Warranty Information
For vehicles repaired under warranty, use the table.
Disclaimer