Fuel Metering System

Some failures of the fuel metering system will result in an Engine Cranks but Won't Run symptom. Refer to Engine Cranks But Does Not Run to determine if the problem is caused by the ignition system, PCM, or fuel pump circuit. Whenever it is determined to be a fuel problem, the Fuel System Diagnosis table will be used. This includes the fuel injectors, the fuel pressure regulator, the fuel pump, and the fuel pump relay. Whenever a problem occurs in the fuel metering system, it usually results in either a rich or lean O2S signal, which causes the PCM to change the fuel calculation (injector pulse width). The change made to the fuel calculation is indicated by a change in the short and long term fuel trim values (-100 percent to 100 percent) which can be monitored by using a scan tool. A momentary change to the fuel calculation is indicated by the short term fuel trim value, while a prolonged change is indicated by the long term fuel trim value. A value of 0 percent indicates that the fuel delivery requires no compensation to maintain the proper air/fuel ratio. A negative value significantly below 0 percent indicates that the fuel system is rich and the fuel delivery is being reduced (decreased injector pulse width). A positive value significantly greater than 0 percent indicates that a lean condition exists and the fuel delivery is being increased (increased injector pulse width).

IMPORTANT: Whenever both fuel trim values are between 0 percent to 100 percent, see DTC P0171 or DTC P0131 tables for items which can cause a lean system. Whenever both fuel trim values are between 0 percent to -100 percent, see DTC P0172 or DTC P0132 for items which can cause the system to run rich.

Listed below are examples of lean and rich conditions with the system in control and out of control.
^ A momentary lean O2S signal (system is in control) will appear on the scan tool as
- Short term fuel trim value above 0 percent (adding fuel).
- Long term fuel trim value around 0 percent.
^ A prolonged lean O2S signal (system is in control) will appear on the scan tool as
- Short term fuel trim value around 0 percent.
- Long term fuel trim value above 0 percent (added fuel).
^ A momentary rich O2S signal (system is in control) will appear on the scan tool as
- Short term fuel trim value less than 0 percent (reducing fuel).
- Long term fuel trim value around 0 percent.
^ A prolonged rich O2S signal (system is in control) will appear on the scan tool as
- Short term fuel trim value around 0 percent.
- Long term fuel trim value less than 0 percent (reduced fuel).
^ A prolonged rich O2S signal (system is out of control) will appear on the scan tool as
- Short term fuel trim value much less than 0 percent (reducing fuel).
- Long term fuel trim value much less than 0 percent (reduced fuel).