Electronic Column Lock Module - Assemble

ASSEMBLY PROCEDURE





1. Install the lock bolt spring (3) into the steering column housing assembly (5).
2. Position the cutout in the lock bolt assembly (4) at the 6 o'clock position.
3. Install the lock bolt assembly (4) into the steering column housing assembly (5).
4. Push the lock bolt assembly (4) into the steering column housing assembly (5) until the lock bolt assembly (4) is flush with the steering column housing assembly (5).
5. Align the lock module assembly (2) with the steering column housing assembly (5).
Install the lock module assembly (2) onto the steering column housing assembly (5).

NOTICE: Refer to Fastener Notice in Service Precautions.

6. Screw the 3 pan head tapping screws (1) into the lock module assembly (2).
- Tighten the 3 pan head tapping screws to 7 Nm (62 inch lbs.).





7. Slide the ignition and key alarm switch assembly (3) into the lock module assembly (1).





8. Snap the electric park lock (2) onto the lock module assembly (1).





9. Reconnect the connector (2) to the electric park lock (1).





10. Install the key alarm connector (1) onto the lock module assembly (2) in the following way:
10.1. Push the key alarm connector (1) into the lock module assembly (2).
10.2. Rotate the key alarm connector (1) 90 degrees so that the key alarm connector locks into place.
10.3. Install the passkey connector into the lock module assembly (2).
11. Install the upper column housing components. Refer to Turn Signal Cancel Cam, Bearing Thrust Washer - Assemble (Floor Shift).