Ignition & Key Alarm Switch - Assemble

ASSEMBLY PROCEDURE





1. Slide the ignition and key alarm switch assembly (2) into the lock module assembly (1).





2. Push the key alarm connector (1) into the lock module assembly (2).
3. Rotate the key alarm connector (1) 90 degrees so that the key alarm connector (1) locks into place.
4. Install the passkey connector into the lock module assembly (2).





5. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulkhead connector (1).





6. Attach the wire harness assembly (1) to the steering column with new wire harness strap (2).
7. Install the upper and lower shrouds. Refer to Trim Covers, Shift Lever Seal - Assemble - Off Vehicle (Column Shift).