Theft Deterrent Module Replacement

REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.

1. Disconnect the negative battery cable.
2. Remove the instrument panel extension.
3. Remove the screw that retains the module to the bracket.
4. Use the following method in order to remove the module from the mounting bracket:
4.1. Slide the module forward
4.2. Pull the module down
5. Remove the electrical connector.

INSTALLATION PROCEDURE
1. Install the electrical connector.
2. Install the module to the mounting bracket.

NOTE: Refer to Fastener Notice in Cautions and Notices.

3. Install the screw in order to retain the module to the bracket.

Tighten
Tighten the screw in order to retain the module to the bracket to 2 N.m (18 lb in).

4. Install the instrument panel extension.
5. Connect the negative battery cable.