A/T Shift Lock Control - Assemble

ASSEMBLY PROCEDURE





1. Install the electrical BTSI actuator to the steering column jacket assembly.
2. Put the column in the neutral position.





3. To adjust the electrical BTSI actuator follow these steps:
3.1. Pull the tab (1) out on the block side (2) of the electrical BTSI actuator.
3.2. Press on the adjuster block (2) to compress the internal adjuster spring to disengage the adjuster teeth. Slide the adjuster block as far away from the solenoid as possible.
3.3. Push the tab (2) in to lock in place.

4. To inspect the electrical BTSI actuator follow these steps:
4.1. Put the gearshift lever in the park position.
4.2. Install the column into the vehicle.
4.3. Release the gearshift lever by pressing the brake pedal.
4.4. Energize the solenoid.
4.5. Readjust if needed.

5. Install the upper and lower shrouds. Refer to Steering Column Trim Covers - Assemble - Off Vehicle.