Finding A Station

AM/FM Stereo:

AM-FM
Press the tune knob in order to change the radio band between AM and FM. The display will indicate the current band and the last radio frequency that was selected on that band.

TUNE
1. Rotate the TUNE knob clockwise in order to increase the AM or FM frequency.
2. Rotate the TUNE knob counterclockwise in order to decrease the AM or FM frequency.

SEEK
1. Press the right arrow button in order to tune into the next station higher in frequency.
2. Press the left arrow button in order to tune into the next station lower in frequency.

SCAN
1. Press both SEEK buttons in order to activate the SCAN mode.
2. SCAN will appear on the display and the radio will stop at every station for a few seconds.
3. Press the right arrow button in order to tune into the next higher station
4. Press the left arrow button in order to tune into the next lower station.
5. Press VOLUME or both SEEK buttons to stop scanning.

PUSH BUTTONS
Up to 14 stations can be preset into the radio's memory using the numbered push buttons (1,3,5, and 7). In order to preset 4 AM and 4 FM stations, perform the following steps:
1. Tune to the desired radio station.
2. Press the SET push button. SET will appear on the display.
3. Press and hold a numbered push button until the SET display goes off. The radio will tune to the preset station the next time the same push button is pressed.

In order to preset 3 additional AM and 3 additional FM stations perform the following steps:
1. Tune to the desired radio station.
2. Press the SET push button. SET will appear on the display.
3. Press and hold two adjacent push buttons (1 and 3) until the SET display goes off. The radio will tune to the preset station the next time both push buttons are pressed.
4. Repeat the first two steps for each remaining pair of push buttons (3 and 5, or 5 and 7).