Throttle Position Sensor: Service and Repair

REMOVAL PROCEDURE




1. Remove the throttle body assembly from the upper intake manifold.




2. Remove the two TP sensor attaching screw assemblies.




3. Remove the TP sensor from throttle body assembly.
4. Remove the TP sensor seal.

INSTALLATION PROCEDURE




1. Install the TP sensor seal over throttle shaft.
2. With throttle valve closed, install the TP sensor on the throttle shaft. Rotate counterclockwise to align mounting holes.





NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the two TP sensor attaching screw assemblies.

Tighten
Tighten the screw assemblies to 2.0 N.m (18.0 lb in).




4. Install the throttle body assembly to the upper intake manifold.