Power Antenna Assembly Replacement

REMOVAL PROCEDURE
1. Remove the antenna cable connector under the right side of the instrument panel.
2. Disconnect the electrical connector for the power antenna motor under the right side of the instrument panel.
3. Push the antenna cable (3) grommet through the cowl panel.
4. Raise and support the hood.
5. Remove the grounding strap (5) from the inner tender.
6. Remove the antenna cable retainer from the inner fender.
7. Remove the 2 bolts (2) retaining the antenna (1) to the inner fender.
8. Pull the antenna assembly downward in order to release the assembly from the fender bezel.
9. Remove the antenna bezel (6) from the fender.
10. Remove the antenna and the cable from the vehicle.

INSTALLATION PROCEDURE
1. Install the antenna bezel (6) to the fender.
2. Install the antenna (1) and the cable (3) to the vehicle.
3. Push the antenna assembly upward in order to insert the assembly into the fender bezel.
4. Install the 2 bolts (2) retaining the antenna to the inner fender.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Tighten
Tighten the bolts (2) retaining the antenna to the inner fender to 11 N.m (97 lb in).

5. Install the grounding strap (5) to the inner fender.
6. Install the antenna cable retainer to the inner fender.
7. From the inside of the vehicle, pull the antenna grommet through the cowl panel.
8. Install the antenna cable connector under the right side of the instrument panel.
9. Connect the electrical connector for the power antenna motor under the right side of the instrument panel.
10. Close the hood.