Park/Turn Signal Lamp Replacement (Uplevel Vehicles)

REMOVAL PROCEDURE
1. Remove the screws (4) that retain the park/[1][2]turn signal lamp to the radiator grille.
2. Remove the park/[1][2]turn signal lamp (3) from the radiator grille.
3. Disconnect the bulb socket(s) (1) from the park/[1][2]turn signal lamp by turning the bulb sockets in a counter-clockwise direction.
4. Remove the bulb(s) (1) from the socket.

INSTALLATION PROCEDURE
1. Connect the bulb(s) (1) into the socket.
2. Connect the bulb socket(s) (1) into the park/[1][2]turn signal lamp.
3. Install the park/[1][2]turn signal lamp (3) to the radiator grille (5).

NOTE: Refer to Fastener Notice in Cautions and Notices.

4. Install the park/[1][2]turn signal lamp retaining screws (4) to the radiator grille.

Tighten
Tighten the screws to 1.5 N.m (13 lb in).