Front

1. Remove the cotter pin.
^ Tighten the hub/rotor bearing nut to 16 Nm (12 ft. lbs.), while turning the wheel forward by hand. This will seat the bearings.

IMPORTANT: Do not back the nut off more than 1/4 turn.

2. Adjust the nut to so that it is just loose. Then, back the nut off until the hole in the spindle aligns with a slot in the nut.
3. Install a new cotter pin.





4. Measure the endplay in the hub/rotor assembly. Proper endplay is 0.03 - 0.20 mm (0.001 - 0.008 inches).