PASSLOCK - Learn Procedure - Using A Tech 2 Scan Tool

1. Using a Tech 2 enter the Service Programming System (SPS).
2. After entering the vehicle information, choose the Request Info soft key on the Tech 2.
3. Select Done and follow the instructions on the Vehicle Set-up screen
4. Disconnect the Tech 2 from the vehicle and connect the Tech 2 to a Techline terminal.
5. At the Techline terminal, select Service Programming System (SPS), select the Terminal to Scan Tool Programming method and then select Done.
6. Follow the instructions on the remaining screens.
7. Select Vehicle Theft Re-learn.
8. Select Program at the summary screen. The terminal will download the information to the Tech 2.
9. Return the Tech 2 to the vehicle and connect the Tech 2 to the diagnostic link connector (DLC).
10. Select Service Programming from the Tech 2 main menu. Answer the prompts regarding the model year and vehicle type. Press the Theft Re-learn soft key on the Tech 2.
11. Follow the instructions on the remaining screens.
^ The PCM and the Passlock control module will prepare for re-learn.
^ A security timer will be on for approximately 10 minutes.
^ When the PCM and the Passlock control module are prepared to re-learn, turn the ignition OFF for 30 seconds and then start the engine.