Ignition & Key Alarm Switch - Assemble - Export

1. Insert J 42759 into the lock module (1) and slide the ignition and key alarm switch assembly (2) in.





2. Push the key alarm connector (1) into the electronic lock module assembly (2).
3. Rotate the key alarm connector (1) 90 degrees so that the key alarm connector (1) locks into place.
4. Install the passkey connector into the electronic lock module assembly (2).





5. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulkhead connector (1).





6. Attach the wire harness strap (2) to the wire harness assembly (1) and the steering column.
7. Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle (Column Shift) or Steering Column Trim Covers - Assemble - Off Vehicle (Floor Shift) or Steering Column Trim Covers - Assemble - Off Vehicle (Export).