Rear Upper

Removal Procedure





1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Support the rear axle.
3. Disconnect the Real Time Damping (RTD) sensor. (if equipped). Refer to Rear Position Sensor Replacement - Automatic Suspension / Service and Repair.
4. Remove the nuts and bolts from the frame bracket.





5. Remove the nuts and bolts from the axle bracket.
6. Remove the upper control arm.


Installation Procedure





1. Install the upper control arm.
2. Install the bolts to the axle bracket.





3. Install the bolts to the frame bracket.

Notice: Refer to Fastener Notice in Service Precautions.

Important: Do not tighten the nuts unless the suspension is at the curb height position.

4. Install the nuts.
- Tighten the bolts to 105 Nm (77 ft. lbs.).
5. Connect the (RTD) sensor. (if equipped). Refer to Rear Position Sensor Replacement - Electronic Suspension - Left (15 Series) or Rear Position Sensor Replacement - Electronic Suspension - Left (25 Series) or Rear Position Sensor Replacement - Electronic Suspension - Right (25 Series) or Rear Position Sensor Replacement - Electronic Suspension - Right (15 Series).
6. Remove the rear axle support.
7. Remove the safety stands.
8. Lower the vehicle.