Installation

Installation
1. Install the gasket onto the axle shaft.
2. Install the gasket and the axle shaft into the axle tube.
2.1. Ensure the shaft splines mesh into the differential side gear.
2.2. Align the holes in the axle flange and the gasket with the holes in the hub.

Notice: Refer to Fastener Notice in Cautions and Notices.

3. Install the axle flange bolts.
Tighten
Tighten the rear axle flange bolts to 156 N.m (115 lb.ft.)
4. Inspect and add axle lubricant to the axle housing.
Lubricant Recommendations.
^ 8.6 inch ring gear rear axles 15-40 mm (0.6 - 1.6 inch) below the fill plug.
^ 9.5 and 10.5 inch ring gear rear axles 15-40 mm (0.4 inch) below the fill plug.