67. Oil Pump, Pump Screen and Deflector Installation

- Tools Required
- J 36660-A Electronic Torque Angle Meter





1. Inspect for properly installed pins (oil pump locator).





Important: Do not reuse the oil pump driveshaft retainer (4).
During assembly, install a NEW oil pump driveshaft retainer.

2. Assemble the oil pump (3), the oil pump driveshaft (5), and a NEW oil pump driveshaft retainer (4).
3. Install the oil pump (3). Position the oil pump onto the pins.

Notice: Refer to Fastener Notice in Service Precautions.

4. Install the crankshaft oil deflector (2) and the nuts (6).
5. Install the bolt (1) attaching the oil pump to the rear crankshaft bearing cap.
- Tighten the oil pump bolt on the first pass to 20 Nm (15 lb ft).
- Tighten the oil pump bolt on the final pass to 65° using the J 36660-A.
- Tighten the crankshaft oil deflector nuts to 40 Nm (30 lb ft).