Antenna: Service and Repair

REMOVAL PROCEDURE
1. Remove the antenna mast.
2. Remove the screws.
3. Remove the bezel.
4. Disconnect the antenna from the extension cable.
5. Remove the antenna assembly.

INSTALLATION PROCEDURE
1. Connect the antenna to the cable assembly.

NOTE: Refer to Fastener Notice in Cautions and Notices.

2. Install the screws.

Tighten
Tighten the screws to 5 N.m (58 lb in).

3. Install the bezel.
4. Install the antenna mast, finger tight plus a quarter turn.

Tighten
Tighten the mast to 4 - 6 N.m (44 lb in).