Rear Axle Housing Cover and Gasket Replacement

Removal Procedure





1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Drain the rear axle. Refer to Lubricant Change.
3. Remove the rear cover bolts (1).
4. Remove the rear cover (2) from the housing.
4.1. Catch the oil in a drain pan.
4.2. Remove any gasket material.


Installation Procedure





1. Install the rear cover (2) and a new gasket.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the rear cover bolts (1).
Tighten the bolts in a crosswise pattern to 40 Nm (30 ft. lbs.).
3. Fill the rear axle to the following levels. Refer to Fluid and Lubricant Recommendations.
^ 8.6 inch ring gear rear axles 15 - 40 mm (0.6 - 1.6 inch) below the fill plug.
^ 9.5 and 10.5 inch ring gear rear axles 0-10 mm (0.4 inch) below the fill plug.
4. Remove the supports and lower the vehicle.