79. Throttle Body Installation

Notice: Refer to Fastener Notice in Service Precautions.





1. Install the throttle body studs (if required).
Tighten the throttle body studs to 6 Nm (53 inch lbs.).

Important: DO NOT reuse the throttle body gasket. Install a NEW gasket during assembly.

2. Install the throttle body gasket (1) to the intake manifold.





3. Install the throttle body and nuts.
Tighten the throttle body nuts to 10 Nm (89 inch lbs.).
4. Install the engine coolant air bleed hose and clamp to the throttle body.





5. Install the engine sight shield bracket and bolts.
Tighten the engine sight shield bracket bolts to 5 Nm (45 inch lbs.).
6. Install the engine sight shield and bolts.
Tighten the engine sight shield bolts to 10 Nm (89 inch lbs.).