Ignition Control Module: Service and Repair

IGNITION COIL AND ICM REPLACEMENT (HVS)

REMOVAL PROCEDURE






1. Remove the air cleaner assembly.
2. In order to gain access to the ignition coil, relocate the engine wiring harness at the left rear side of the engine.
3. Disconnect the electrical connectors for the ignition coil and the ICM.






4. Remove the bolts retaining the coil to the intake manifold.
5. Remove the ignition coil.

INSTALLATION PROCEDURE

NOTE: Refer to Fastener Notice in Service Precautions.






1. Install the ignition coil and the bolts to the intake manifold.

Tighten
Tighten the bolts to 27 N.m (22 lb in).

2. Install the electrical connectors.
3. Install the ignition coil wire to coil.

The wire must not touch anything like the dip stick. Rubbing will make a ground/short after time of use.
4. Relocate the engine wiring harness at the left rear side of the engine.






5. Install the air cleaner assembly.