Hood: Service and Repair

Hood Replacement

Removal Procedure

1. Place a padded table in front of the vehicle.
2. Tilt the hood forward.
3. Support the hood.





Caution: The hood check cable is under tension when the hood is opened. Use care when removing the hood check cable to prevent personal injury or damage to the vehicle.

4. Remove the cotter and clevis pin where the check cable attaches to the radiator support brace.
5. Ease the hood onto the table.
6. Remove the headlamp wiring harness connector at the right front of the hood.




7. Remove the hinge bolt.
8. Remove the hood.

Installation Procedure

1. Place the hood on the padded table in front of the vehicle.
2. Align the hinge bushings to the holes in the hinge bracket.





Notice: Refer to Fastener Notice in Cautions and Notices.

3. Install the hood hinge bolt through the bracket and the hinge.

Tighten the bolt to 30 Nm (22 lb ft).

4. Connect the harness connector to the headlamp harness at the right front of the hood.
5. While supporting the hood, align the brace spring to the radiator support brace.




6. Install the cotter pin and the clevis pin through the following components:

* The brace spring
* The radiator support bracket