Turn Signal and Multifunction Switch Assembly - Assemble - Off Vehicle

Turn Signal and Multifunction Switch Assembly - Assemble - Off Vehicle




1. Thread the turn signal switch assembly connector through the steering column housing assembly, if the connector is hanging.





Notice: Refer to Fastener Notice in Cautions and Notices.

2. Install the turn signal switch assembly and secure using the 3 binding head cross recess screws (1).

Tighten the 3 binding head cross recess screws (1) to 3.5 Nm (31 lb in).

3. Lubricate the signal switch arm actuator (3) with lithium grease.
4. Install the signal switch arm actuator (3) onto the turn signal switch assembly.
5. Secure the signal switch arm actuator (3) using the round washer head screw (2).

Tighten the round washer head screw (2) to 2.5 Nm (22 lb in).




6. Install the terminal connector to the turn signal switch assembly connector.
7. Install the terminal connector to the dimmer switch assembly.




8. Pull the turn signal switch assembly connector towards the base of the column.
9. Insert the wire protector into the steering column bracket.
10. Insert the steering column wire harness into the steering column wire harness strap.
11. Install the turn signal cancel cam, bearing thrust washer. Refer to Turn Signal Cancel Cam and Bearing Thrust Washer - Assemble - Off Vehicle Turn Signal Cancel Cam and Bearing Thrust Washer - Assemble - Off Vehicle.