Accelerator Pedal Position Sensor: Service and Repair

Accelerator Pedal Position Sensor Replacement

Removal Procedure





Notice: Handle the electronic throttle control components carefully. Use cleanliness in order to prevent damage. Do not drop the electronic throttle control components. Do not roughly handle the electronic throttle control components. Do not immerse the electronic throttle control components in cleaning solvents of any type.

1. Disconnect the accelerator pedal sensor module (1) electrical connector.
2. Remove the accelerator pedal mounting nuts (3,4) from the cowl (2).
3. Remove the accelerator pedal assembly with bracket (1).

Installation Procedure





Notice: Refer to Fastener Notice in Cautions and Notices.

Important: Always use a torque wrench in order to obtain the proper torque.


1. Install the accelerator pedal assembly with bracket to the cowl (1).

Tighten the accelerator pedal bracket mounting nuts (3,4) to 36 Nm (27 lb ft).

2. Connect the accelerator pedal sensor module (1) electrical connector.
3. Inspect for complete throttle opening and closing positions. Use a scan tool to monitor the throttle angles while operating the accelerator pedal to open and close the throttle. The accelerator pedal should operate freely without binding between full closed throttle and wide open throttle.
4. Inspect for poor carpet fit under the accelerator pedal.