Diagnostic System Check

POWERTRAIN ON BOARD DIAGNOSTIC OBD SYSTEM CHECK









Circuit Description
The Powertrain On-Board Diagnostic (OBD) System Check is an organized approach to identifying a problem created by a control module system malfunction. The OBD is the starting point for any driveability concern diagnosis. The OBD directs the service technician to the next logical step in diagnosing the concern.

Perform this check only if there is a driveability complaint or if you have been sent to this system check from another section in the service information.

Understanding the table properly reduces the diagnostic time. Proper use of the OBD helps prevent the unnecessary replacement of good parts.

Diagnostic Aids

Important: Do not clear the DTCs unless directed by a diagnostic procedure. Clearing the DTCs will also clear valuable Freeze Frame and Failure Records data.

Inspect all related wiring and connections including the connections at the vehicle control module (VCM). These may cause an intermittent malfunction.

Any base engine problem such as distributor timing, valve timing, or intake gasket leaks could alter the scan tool data.

An intermittent may be caused by any of the following conditions:
• A poor connection
• Rubbed through wire insulation
• A broken wire inside the insulation

Thoroughly inspect any circuitry that is suspected of causing the intermittent complaint. Testing For Intermittent and Poor Connections

If a repair is necessary, refer to Wiring Repairs or Connector Repairs. Diagnostic Aids

Test Description
The numbers below refer to the step numbers on the diagnostic table.

1. This step determines if the scan tool powers up when connected to the data link connector (DLC).

2. The malfunction indicator lamp (MIL) should be ON when you turn ON the ignition.

4. Refer to Diagnostic Trouble Code (DTC) List/Type for a list of valid DTCs. Diagnostic Trouble Code List/Type

5. Refer to Data Link Connector Schematics in Engine Controls in order to determine all of the modules communicating on the Class 2 Serial Data circuit. If any of the modules are not present in the Diagnostic Circuit Check, then the modules never established communications. The scan tool will indicate a YES state for communicating modules and a NO state for modules that had established yet no longer communicate. Engine Controls

7. If the vehicle does not start or starts and stalls, the Passlock system could be the cause.

8. This test determines if the VCM can control the MIL.

9. Comparing the ACTUAL and TYPICAL scan tool data values will aid in determining whether an engine parameter is within limits. For example, advanced timing can substantially alter sensor values.