Turn Signal & Multifunction Switch - Assemble - Export

Notice: Refer to Fastener Notice in Service Precautions.

Important: Be sure that the electrical contact of the turn signal and multifunction switch assembly (2) rests on the turn signal cancel cam assembly.





1. Install the turn signal and multifunction switch assembly (2) onto the steering column tilt head assembly.
Screw the 2 pan head tapping screws (1) into the turn signal and multifunction assembly (2).
- Tighten the 2 pan head tapping screws to 7 Nm (62 inch lbs.).





2. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulkhead connector (1).





3. Reconnect the turn signal and multifunction switch assembly connector to the inflatable restraint steering wheel module coil connector.
4. Attach the wire harness assembly (1) to the steering column with wire harness strap (2).
5. Install the upper and lower trim covers. Refer to Steering Column Tam Covers - Assemble - Off Vehicle (Column Shift) or Steering Column Trim Covers - Assemble - Off Vehicle (Floor Shift) or Steering Column Trim Covers - Assemble - Off Vehicle (Export).