Cylinder Head Torque & Sequence

CYLINDER HEAD BOLT

NOTE:
- Do not reuse the cylinder head bolts. Install NEW cylinder head bolts during assembly.
- Do not use any type sealant on the cylinder head gasket (unless specified).







1. Tighten the M11 cylinder head bolts a first pass in sequence to 30 N.m (22 lb ft).
2. Tighten the M11 cylinder head bolts a second pass in sequence to 90 degrees using the J 36660-A.
3. Tighten the M11 cylinder head bolts (1,2,3,4,5,6,7,8) to 90 degrees and the M11 cylinder head bolts (9 and 10) to 50 degrees a final pass in sequence to using the J 36660-A.
4. Tighten the M8 cylinder head bolts (11,12,13,14,15) to 30 N.m (22 lb ft). Begin with the center bolt (11) and alternating side-to-side, work outward tightening all of the bolts.