Operation CHARM: Car repair manuals for everyone.

Rear

Removal Procedure





1. Raise the vehicle. Support the vehicle with suitable safety stands. Refer to Vehicle Lifting.
2. Remove the following parts from the stabilizer links:
- The lower nuts (10,24)
- The washers (11,23)
- The bolts (16,20)
3. Remove the bolts (17) from the clamps.
4. Remove the clamps (14,19) and the insulators (15,18).
5. Remove the stabilizer shaft (4).

Installation Procedure





1. Install the stabilizer shaft (4) to the rear axle.
2. Install the insulators (15,18) and the clamps (14,19).
3. Install the bolts (17) to the clamps. Do not tighten.
4. Install the lower bolts through the following components:
- The stabilizer shaft ends (4)
- The stabilizer links (12,22)
- The washers (11,23)

Notice: Refer to Fastener Notice in Service Precautions.

5. Install the nuts (10,24).
- Tighten the clamp bolts to 34 Nm (25 ft. lbs.).
- Tighten the stabilizer link nuts to 45 Nm (33 ft. lbs.).