Rear Position Sensor Replacement - Left

Removal Procedure





1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the wheel from the vehicle. Refer to Tire and Wheel Removal and Installation.
3. Disconnect the sensor harness connector from the vehicle harness connector.





4. Remove the bolts.
5. Remove the position sensor from the vehicle.
6. Disconnect the sensor link from the ball stud.


Installation Procedure





1. Install the position sensor on the vehicle.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the bolts.
^ Tighten the bolts to 12 Nm (106 inch lbs.).
3. Connect the sensor link to the ball stud.





4. Connect the sensor harness connector to the vehicle harness connector.
5. Install the wheel onto the vehicle. Refer to Tire and Wheel Removal and Installation.
6. Lower the vehicle.