Steering Column Trim Covers - Replacement

STEERING COLUMN TRIM COVERS REPLACEMENT

Removal Procedure

1. Disable the SIR system, refer to Air Bag(s) Arming and Disarming

2. Remove the steering wheel, refer to Service and Repair






3. Remove the 2 pan head tapping screws (1) from the lower shroud (2).






4. Remove the lower shroud from the upper shroud.

5. Tilt the lower shroud down.

6. Slide the lower shroud backward in order to disengage the locking tabs.






7. Remove the shroud protector (1) from the lower shroud (2).






8. Remove the 2 TORX head screws (1) from the upper shroud (2).

9. Remove the ignition lock cylinder, refer to Ignition Switch

10. Remove the upper shroud (2) from the steering column.

Installation Procedure






1. Install the upper shroud (2) onto the steering column.

2. Install the ignition lock cylinder, refer to Ignition Switch

NOTICE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Screw the 2 TORX head screws (1) into the upper shroud (2).

4. Tighten the 2 TORX head screws to 1.5 Nm (13 lb.in).






5. Install the shroud protector (1) onto the lower shroud (2).






IMPORTANT: The shift lever seal must be seated in the shrouds.

6. Install the lower shroud onto the upper shroud.

7. Match the tab slots on the lower shroud with the locking tabs on the upper shroud.

8. Tilt the lower shroud up.

9. Slide the lower shroud forward until the locking tabs snap into the tab slots.






10. Screw the 2 pan head tapping screws (1) into the lower shroud (2).

11. Tighten the 2 pan head tapping screws to 3.5 Nm (31 lb.in).

12. Install the steering wheel, refer to Service and Repair

13. Enable the SIR system, refer to Air Bag(s) Arming and Disarming