Steering Linkage (Non-Rack & Pinion)

Removal Procedure

- Tools Required
- J 24319-01 Universal Steering Linkage Puller
- J 29193 Steering Linkage Installer (12 mm)

Important: Use the J24319-01 in order to separate all the tie rods and ball joints.





1. Raise the vehicle. Suitably support the vehicle with jack stands. Refer to Vehicle Lifting.
2. Remove the nut (2) from the outer tie rod ball stud (3).





3. Use the J 24319-01 in order to remove the outer tie rod ball stud from the steering knuckle.
4. Remove the tie rod end (4) from the shaft (6) by loosening the jam nut (5).
Do not reuse the nut.





5. Inspect the shaft (6) for bent or damaged threads.
6. Clean the tapered surface of the steering knuckle (1).


Installation Procedure





1. Lubricate the tie rod threads with chassis lubricant. Refer to Fluid and Lubricant Recommendations.
2. Install the tie rod end (4) to the shaft (6).
3. Install the outer tie rod ball stud (3) to the steering knuckle (1).

Notice: Refer to Fastener Notice in Service Precautions.

4. Use the J29193 in order to install the outer tie rod ball stud.
- Tighten the J 29193 to 54 Nm (40 ft. lbs.) in order to seat the tapers.





5. Install the new prevailing torque nut (2) to the outer rod ball stud (3).
- Tighten the new prevailing torque nut (2) to 45 Nm (33 ft. lbs.).
6. Adjust the front toe. Refer to Measuring Wheel Alignment.
7. Tighten the jam nut (5).
- Tighten the jam nut to 68 Nm (50 ft. lbs.).