Electronic Column Lock Module - Assemble - Export

- Tools Required
- J 42759 Ignition Switch Connector Release Tool





1. Install the lock bolt spring (3) into the steering column tilt head assembly (5).
2. Position the cutout in the lock bolt assembly (4) at the 6 o'clock position.
3. Install the lock bolt assembly (4) into the steering column tilt head assembly (5).
4. Push the lock bolt assembly (4) into the steering column tilt head assembly (5) until the lock bolt assembly is flush with the steering column tilt head assembly (5).
5. Align the electronic lock module assembly (2) with the steering column tilt head assembly (5).

Notice: Refer to Fastener Notice in Service Precautions.

6. Screw the 3 TORX screws (1) into the electronic lock module assembly (2).
- Tighten the 3 TORX screws to 7 Nm (62 inch lbs.).





7. Insert J 42759 into the electronic lock module assembly (1) and slide the ignition and key alarm switch assembly (2).





8. Push the key alarm connector (1) into the electronic lock module assembly (2).
9. Rotate the key alarm connector (1) 90 degrees so that the key alarm connector (1) locks into place.
10. Install the passkey connector into the electronic lock module assembly (2).





11. Place steering column lock cylinder set into the OFF position.
12. Place the shift lever clevis into the PARK position.
13. Press the locking tab on the end of the park lock cable assembly (1) into the slot in the electronic lock module assembly.
14. Install the steering column tilt head components. Refer to Steering Column Tilt Head Housing -Assemble - Off Vehicle (Column Shift) or Steering Column Tilt Head Housing - Assemble - Off Vehicle (Floor Shift) or Steering Column Tilt Head Housing - Assemble - Off Vehicle (Export).