Fuel Tank Pressure Sensor: Service and Repair

REMOVAL PROCEDURE

TOOL REQUIRED
J 34730-1A Fuel Pressure Gauge

CAUTION: Refer to Battery Disconnect Caution in Service precautions.

1. Disconnect the negative battery cable.
2. Relieve the fuel pressure. Refer to Fuel Pressure Relief Procedure. Service and Repair
3. Drain the fuel tank. Refer to Fuel Tank Draining Procedure. Procedures
4. Remove the fuel tank.
5. Disconnect the fuel tank pressure sensor electrical connector.
6. Remove the fuel tank pressure sensor (1) from fuel sender assembly (2).

INSTALLATION PROCEDURE
1. Install the fuel tank pressure sensor (1) on the fuel sender assembly (2).
2. Connect the fuel tank pressure sensor electrical connector.
3. Install the fuel tank.
4. Refill the fuel tank.
5. Connect the negative battery cable.
6. Install the fuel filler cap.
7. Inspect for leaks.
7.1. Turn ON the ignition switch for 2 seconds.
7.2. Turn OFF the ignition switch for 10 seconds.
7.3. Turn ON the ignition switch.
7.4. Inspect for fuel leaks.