Cassette Tape Player

1. In order to play a tape, the ignition lock cylinder must be in the ACCESSORY or RUN position and the receiver must be turned ON.
Tapes are end-loaded into the cassette player.
2. Insert the tape squarely through the door, exposed tape side of the cassette facing to the right.
3. When the tape is fully inserted, the AM/FM portion of the radio will turn off and the tape will begin playing.
4. The tape players works best with tapes that are 30-45 minutes long on each side.
Longer running tapes may not work well in these players because they are usually too thin.
5. Once the tape is playing, use the upper and lower knobs for the volume, the balance and the fade just as with the radio.
An arrow indicates which side of the tape is being played.
6. Press the SEEK right arrow key in order to fast forward the tape.
The tape will advance rapidly until the SEEK left arrow is pressed.
7. Press the SEEK left arrow key in order to rewind the tape.
The tape will rewind rapidly until the SEEK right arrow is pressed.
8. Press the upper knob in order or to go from one side of the tape to the other.
9. Press the EJECT push button in order to remove the tape or in order to stop the tape and switch to the radio.

UM6: For a description of the RPO Code(s) shown in this article, refer to the RPO Code List found at Vehicle/Application and ID RPO Codes