Endgate Identification Lamp Replacement

REMOVAL PROCEDURE
Replace the lens, the lamp, and the base as one assembly.
1. Make sure the headlamp switch is in the OFF position.
2. Remove the lens.
3. Remove the 2 screws that retain the lamp assembly to the vehicle.
4. Remove the lamp assembly.
5. Disconnect the electrical connector.

INSTALLATION PROCEDURE
1. Connect the electrical connector.
2. Install the lamp assembly to the endgate.

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the 2 screws to retain the lamp assembly to the vehicle.

Tighten
Tighten the screws to 2 N.m (18 lb in).

4. Install the lens.