85. Engine Wiring Harness Assembly Installation

^ Tools Required
- J 41515-A Glow Plug Socket
- J 39083 Glow Plug Connector Tool





1. Install the crankshaft position sensor in the front cover (if equipped).





Notice: Refer to Fastener Notice in Service Precautions.

2. Install the crankshaft position sensor bolt (if equipped).
^ Tighten the crankshaft position sensor bolt to 23 Nm (17 lb ft) (if equipped).





3. Install the glow plugs using the J 41515-A.
^ Tighten the glow plugs to 22 Nm (16 lb ft).





4. Install the heat shields on cylinders number 4 and 6.
5. Using J 39083 install the jumper wires to cylinders 4 and 6.





6. Place the harness in the engine valley.
7. Plug in or connect all the wiring harness connectors to devices or attachment points.