Oil Pressure Sensor: Service and Repair

Removal Procedure

^ Tools Required
- J 41712 Oil Pressure Sending Unit Socket





1. Remove the engine cover from the engine block.
2. Remove the fuel filter/water separator from the lower intake manifold and position to the side.
3. Remove the electrical connector from the oil pressure sending unit.





4. Use the J 41712 to remove the oil pressure sending unit from the engine block.


Installation Procedure

^ Tools Required
- J 41712 Oil Pressure Sending Unit Socket

Notice: Refer to Fastener Notice in Service Precautions.





1. Use the J 41712 to install the oil pressure sending unit to the engine block.
^ Tighten the oil pressure sending unit to 12 Nm (9 ft. lbs.).
2. Install the electrical connector to the oil pressure sending unit.





3. Install the fuel filter/water separator to the lower intake manifold.
4. Install the engine cover to the engine block