Fuel Filter: Service and Repair

REMOVAL PROCEDURE




1. Relieve the fuel pressure. Refer to Fuel Pressure Relief Procedure.
2. Remove the fuel filter quick-connect fitting.
3. Remove the fuel filter rut.




4. Remove the clamp bolt.
5. Remove the filter and the clamp from the fuel pipes.




6. Remove the clamp from the filter.

INSTALLATION PROCEDURE

NOTE: Always re-attach the fuel lines and fuel filter with all original type fasteners and hardware.
Do not repair sections of fuel pipes.




1. Install the clamp to the fuel filter.




2. Install the filter and clamp to the fuel pipes.
3. Install the clamp bolt.




4. Install the fuel filter nut.
5. Install the fuel filter quick-connect fitting.
6. Connect the negative battery cable.
7. Inspect for fuel leaks through the following steps:
7.1. Turn On the ignition, with the engine OFF for 2 seconds.
7.2. Turn OFF the ignition for 10 seconds.
7.3. Turn On the ignition, with the engine OFF.
7.4. Inspect for fuel leaks.