Ignition & Key Alarm Switch - Assemble

1. Slide the ignition and key alarm switch assembly (3) into the electronic lock module assembly (1).





2. Install the key alarm connector (1) into the electronic lock module assembly (2).
2.1. Push the key alarm connector (1) into the electronic lock module assembly (2).
2.2. Rotate the key alarm connector (1) 90 degrees so that the key alarm connector (1) locks into place.
2.3. Install the passkey connector into the electronic lock module assembly (2).





3. Snap the electric park lock (2) onto the electronic lock module assembly (1).





4. Reconnect the connector (2) to the electric park lock (1).





5. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulkhead connector (1).





6. Attach the wire harness assembly (1) to the steering column wire harness strap (2).
7. Install the upper and lower trim covers. Refer to Trim Covers, Shift Lever Seal - Assemble - Off Vehicle (Column Shift) or Trim Covers, Shift Lever Seal - Assemble - Off Vehicle (Floor Shift).