Ignition Switch

Removal Procedure

Caution: Refer to SIR Handling Caution In Service Precautions.





1. Disable the SIR system. Refer to Disabling the SIR System in Air Bag Systems.
2. Remove the steering column trim covers from the steering column. Refer to Steering Column Trim Cover Replacement - On Vehicle.
3. Disconnect the steering column electrical connectors.





4. Remove the wire harness assembly (1) from the wire harness straps (2) and the steering column.





5. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly out of the bulkhead connector (1).





6. Remove the key alarm connector (1) from the lock module assembly (2) in the following way:
6.1. Rotate the key alarm connector (1) 90 degrees.
6.2. Pull the key alarm connector (1) out of the lock module assembly (2).
6.3. Remove the passkey connector from the lock module assembly (2).





7. Remove the connector (2) from the electric park lock (1), for vehicle equipped with floor shifters.





8. Slide the ignition and key alarm switch assembly (2) out of the lock module assembly (1) by releasing the tabs.

Installation Procedure





1. Slide the ignition and key alarm switch assembly (2) into the lock module assembly (1).





2. Install the key alarm connector (1) into the lock module assembly (2).
2.1. Push the key alarm connector (1) into the lock module assembly (2).
2.2. Rotate the key alarm connector (1) 90 degrees so that the key alarm connector (1) locks into place.
2.3. Install the passkey connector into the lock module assembly (2).





3. Snap the electric park lock (2) onto the lock module assembly (2), for vehicle equipped with floor shifters.





4. Reconnect the connector (2) to the electric park lock (1), for vehicle equipped with floor shifters.





5. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulkhead connector (1).





6. Attach the wire harness assembly (1) to the steering column with new wire harness straps (2).





7. Connect the steering column electrical connectors.
8. Install the steering column trim covers to the steering column, Refer to Steering Column Trim Cover Replacement - On Vehicle.
9. Enable the SIR system. Refer to Enabling the SIR System in Air Bag Systems.