Trim Covers, Shift Lever Seal - Assemble

- Tools Required
- J 41352 Modular Column Holding Fixture
- J 42640 Steering Column Anti Rotation Pin





1. Install the upper trim cover (2) onto the steering column.

Notice: Refer to Fastener Notice in Service Precautions.

2. Screw the 2 TORX8 head screws (1) into the upper trim cover (2).
- Tighten the 2 TORX0 head screws to 1.5 Nm (13 inch lbs.).





3. Install the trim cover protector (1) onto the lower trim cover (2).





4. Install the shift lever seal (2) into the shift lever (4).
5. Install the shift lever assembly (4) into the steering column.
6. Install the shift lever screw (3) into the shift lever assembly (4).
- Tighten the screw to 1.5 Nm (13 inch lbs.).
7. Slide the shift lever seal (2) down the shift lever (4).

Important: The shift lever seal must seat on the grooves of the trim covers.





8. Install the lower trim cover onto the upper trim cover.
9. Match the tab slots on the lower trim cover with the locking tabs on the upper trim cover.
10. Tiff the lower trim cover up.
11. Slide the lower trim cover forward until the locking tabs snap into the tab slots.





12. Screw the 2 pan head tapping screws (1) into the lower trim cover (2).
- Tighten the 2 pan head tapping screws to 3.5 Nm (31 inch lbs.).





13. Remove J 42640 from the lower trim cover of the steering column.
14. Remove the steering column and J 41352 from the vise.